View Single Post
  #3   Report Post  
Old 26-11-2004, 05:33 PM
Jürgen Beisser
 
Posts: n/a
Default


"Jürgen Beisser" schrieb im Newsbeitrag
...

"Scott Rogahn" schrieb im Newsbeitrag
...
I am looking for a better needle valve. I am presently using a cheap home
depot valve that just doesn't work. You can go from no bubbles to blowing
the reactor of the side of the tank in about a ¼ turn even at pressures
less than 5PSI. I presently use this by closing the valve all the way and
adjusting the pressure to get the desired flow rate. This doesn't work
very well the flow rate fluctuates considerably, from almost dead stop to
way too fast. It is a new regulator due to the old one developing a leak
an emptying my bottle, but I had the same problem with the old regulator.
The new regulator can be seen here
....


Scott,

I don't know whether Dennerle (Germany) sells equipment to the area where
you live. They have introduced a pretty good one which you can adjust
easily because of the reduction gear. Look at the bottom of their page:
http://www.dennerle.de/ENGLISCH/E_CO...EUframeset.htm
I have the predecessor of this type and I am very satisfied with it.

Regards
Juergen


Scott,

just found out that you have to click on "Classic Line" from the page
mentioned above to get to the page with the new regulator.

Regards
Juergen