View Single Post
  #8   Report Post  
Old 20-04-2003, 06:15 AM
Posts: n/a
Default Question about CO2 levels in my tank

A DIY system is fine and I was planning on doing so, but I got the
entire Nutrafin system for only $15. I think it looks a lot better
than most DIY systems. I don't use Nutrafin's yeast and stabilizer
packets. I use my own. Regardless, it works well for me, and for the
price, I can't complain.

I little more info though... I let some water sit out for some time
and than ran another pH test. This time my tap water had a pH of
about 8.4.


On Tue, 17 Dec 2002 16:58:34 GMT, "STEVE KREUTZER"

I also thought it was kind of silly to buy the Nutrafin system instead of a
DIY. But, I saw the diffuser for $12 in the lfs (you can get it for $10
online) and bought it. I made my own yeast bottle and use my own yeast and
sugar. I have had good results and it is fun to look at.

Ed wrote in message ...
On Tue, 17 Dec 2002 04:16:08 GMT, NjF wrote:

Since you were so helpful answering my last question, here is another
for the experts.

Before setting up the tank I tested tap water for pH, KH, and GH (7.8,
8dKH, 17dGH).

After running for a couple of weeks with injected CO2 pH remains
stable at 7.8 with KH and GH not changing as well. The co2 system is
Nutrafin's Natural Plant System which I purchased because I had read
several posts recommending them (or at least the bubble

As I understand it, co2 levels in the tank are directly related to pH
and KH. I don't know the algorithm, nor do I particularly care what
it is, but Chuck's planted aquarium page has a calculator that will
figure out the ppm of co2 based on the numbers you input for pH and
KH. Both his table and calculator give me a reading of about 3.8ppm
of co2 in the water, which is exactly where I started off before
adding co2.

The water is not being agitated in any real way as to cause the co2 to
escape. When leaving the end of the tube, the co2 bubbles are large,
but gradually decrease in size as they travel up the diffuser (I take
this as meaning the co2 is being dissolved). What do I need to do to
increase the levels of co2 in the water?

BTW, I get 1 bubble of co2 about every 3 seconds with about 4 bubbles
in the counter at any given time.

The tank is 10g with 15watts of light (will be upgraded shortly).

Any help is greatly appreciated. I have enjoyed reading many of your
posts already.


My LFS replaced one an old Tetra CO2 cannister with one of these Nutra
Fin CO2 gizmo's.... the tank has been suffering ever since.

I can tell you that I am not impressed with this system at all. I
think the normal home made DIY systems are much more effective and
cost quite a bit less to construct and maintain.