Suffolk Punch 35s setup
 

Hello all.
I have recently cleaned and redone the carburettor on my Suffolk Punch 35s.

I have put it all together and it starts fine, but cannot get it to idle properly.

I know there is an idle screw and a mixture screw. Also there is a screw in the middle of were the float chamber is.

There are various springs etc.

I haven't got the repair manual or instructions.

Does anyone know or have any info as how to setup this carburettor to run perfectly or can anyone guide me as to were to get the info from..

Thank you

Suffolk Punch 35s setup
 

Merky wrote:
Hello all.
I have recently cleaned and redone the carburettor on my Suffolk Punch
35s.

I have put it all together and it starts fine, but cannot get it to idle
properly.

I know there is an idle screw and a mixture screw. Also there is a screw
in the middle of were the float chamber is.

There are various springs etc.

I haven't got the repair manual or instructions.

Does anyone know or have any info as how to setup this carburettor to
run perfectly or can anyone guide me as to were to get the info from..

Thank you




It needs to be adjusted by someone experienced. It has adjustments
because no 2 are the same. No one in a newsgroup can (reliably) tell you
how to set it to "run perfectly".

Take it to a shop and pay them to adjust it. It will take them less than
5 minutes and they can't charge much for that. In addition they will
likely point out any other obvious problems that you do not have the
experience to spot.

--
Art