GardenBanter.co.uk

GardenBanter.co.uk (https://www.gardenbanter.co.uk/)
-   Lawns (https://www.gardenbanter.co.uk/lawns/)
-   -   Tiller (https://www.gardenbanter.co.uk/lawns/204988-tiller.html)

HL B123 31-08-2012 06:35 PM

Tiller
 
Mongomery Ward 5HP Briggs Stratton engine . Cannot find model # on motor
or tiller or carburetor , This was gave to me by a fellow gardener , It
will start and run if you put gas in the carb. But quits as soon as the
gas is gone . Any thoughts or suggestions would be appreciated .Also if
parts would still be available. thanks have a
good day hlb


[email protected][_2_] 01-09-2012 04:33 PM

Tiller
 
On Aug 31, 12:40*pm, (HL B123) wrote:
Mongomery Ward 5HP Briggs Stratton engine . Cannot find model # on motor
or tiller or carburetor , This was gave to me by a fellow gardener , *It
will start and run if you put gas in the carb. But quits as soon as the
gas is gone . Any thoughts or suggestions would be appreciated .Also if
parts would still be available. * * * * * * * * * * * *thanks *have a
good day * hlb


Usually problems like this are a carb fouled by
deposits from gas. The problem has gotten worse
in recent years from ethanol being added to gas,
which attracts water.

You can remove the carb, take it apart, clean it up
with some carb or brake cleaner, and put it back
together. To do so, you need a carb rebuild kit
which includes new needle valves, gaskets, etc.
It also includes welch plugs, which are like little
metal discs that are sometimes used to cover
up access ports in the carb. To clean it thoroughly,
you pry out the old ones, then tap back in new ones.
You're also supposed to coat the edges of the
plugs with nail polish to seal them.

The carb should have it;s own part number on it
and that is all you need to get the right rebuild kit.
Usually the carbs are used on a lot of models and
available going back many years. Make sure you
also buy a gasket that goes between the carb and
the intake, that one does not come with the kit.
You can find the kit online, Ebay has a lot of them,
they are about $10.

Since you don't have a service manual, before
you remove the two needle valves, turn them in
gently all the way and count the rotations. When
you reinstall, set to the same. One is the idle
mix adjustment, the other the full power mix.
With it running you can then further adjust them
so that it runs smooth at idle and full power.

You could also try spraying the carb with carb
cleaner, that sometimes works, but in my
experience, not that often. Also check that gas
is making it to the carb, ie no kinked hose,
obstruction, etc.


All times are GMT +1. The time now is 10:19 AM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
GardenBanter