Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Old 30-06-2003, 09:20 PM
JerryO
 
Posts: n/a
Default sealed hydrostatic transmission failing

I bought a 17 hp murray in 1999 with a foot operated hydrostatic
transmission. My wife has put 400 hours on the mower, so far.

This summer, my wife was complaining that it wouldn't climb hills. It
finally got to the point that it would stop on flat ground.

When I tried it, I found it did not pull at all. I cleaned the grass
out of behind the clutch linkage with a small improvement. Then I put
a new drive belt on (and deglazed the pulleys). More improvement, but
it still would not pull a hill. I tried a 20 degree hill (that's 35%
for those who prefer percent) and went up about 5 feet, then coasted
back down.

This suggested air in the hydro unit, or something slipping do to the
pressure to force the speed change.

I removed the transmission and tried to split the cases, but wasn't
able to break the sealant loose. I did notice that the bellows
indicated the hydro was overfull??? I also found a fill plug (a rubber
second plug under the fan, as well as a larger plug in the gear
portion of the unit). A large whoosh of air went thru the hole when I
pulled the plug.

I removed the four screws holding the bellows (t25 with a pin so a
normal wrench doesn't work) by slotting the screws and useing a normal
flat bladed screwdriver.

Looking into the bellows chamber, I could see the oil level was down a
bunch. I could also see that the pump was based on a round drum which
slid up and down for forward and reverse. It must be a (awe memory!!)
pump with the slideing plates. ie. it isn't a piston pump with a
swashplate control. The hydraulic motor appears to be a similar unit
without a variable displacement.

As the unit has no recommendation for type of fluid (except it is a
special synthetic), I tried to guess at the viscosity and thought it
was in the 5-30 to 10-40 range. Since we have no reason to drive it
when it is below 40F, I though a thicker oil would be OK. And I had
some mobil 1 20-50 (ie V-twin motorcycle oil) which has a very high
temperature rateing.

I got about 1 quart out and put about 1 1/2 quarts back into the hydro
unit. And made a special effort to get all the air out!!!

The result is that my wife says it pulls better than new.


The point of this,
-- I only need to pull the battery,
-- pull the small rubber plug under the fan,
-- and fill the hydro unit to get all the air out of the unit.

ps. No leaks were evident, though the unit was covered in oily dirt.

JerryO

Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is Off
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Honda 2113 hydrostatic badger12 Lawns 2 12-06-2010 09:05 PM
What is the self life of grass seeds (sealed bag) lbbss Gardening 4 15-09-2008 04:19 PM
2007 Topps Football Factory Sealed Hobby Version Sets with all 440 Cards including Tom Brady, Peyton Mannning, Adrian Peterson Rookie and more, plus 2006 and 2005 factory sets. www.SMCCI.com Ponds 0 25-12-2007 10:01 PM
Hermetically sealed aquarium Ray72 Freshwater Aquaria Plants 0 20-12-2006 12:44 AM
Craftsman lawn tractor hydrostatic tranny info needed [email protected] Gardening 1 07-04-2005 02:05 AM


All times are GMT +1. The time now is 07:19 PM.

Powered by vBulletin® Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
Copyright 2004-2019 GardenBanter.co.uk.
The comments are property of their posters.
 

About Us

"It's about Gardening"

 

Copyright © 2017