GardenBanter.co.uk

GardenBanter.co.uk (https://www.gardenbanter.co.uk/)
-   United Kingdom (https://www.gardenbanter.co.uk/united-kingdom/)
-   -   B&Q polycarbonate glazing pack (https://www.gardenbanter.co.uk/united-kingdom/156987-b-q-polycarbonate-glazing-pack.html)

computar2006 17-04-2007 10:45 PM

B&Q polycarbonate glazing pack
 
Thank goodness for B&Q's no quibble refund policy. I had bought a
polycarbonate glazing pack (a green colored pack). It's one of those
packs that you can't open and look inside until you get it home and
then you discover it's a £80 pig in a poke. I bought an 8 x 6 foot
greenhouse from B&Q about five years ago and the polycarbonate pack I
bought was for an 8 x 6, but the panels were not wide enough and there
wasn't enough to glaze the whole greenhouse. It also said on the
side of the pack "base included", but there was nothing resembling a
base in the pack, just a load of polycarbonate panels so thin that
they resembled plastic cake boxes more than greenhouse glazing. I
tried fitting a few of the panels and needed at least double the
amount of clips I would use for glass, that's if you don't want the
panels to become airborne. You don't get any glazing clips with this
pack either.


Geoff[_6_] 18-04-2007 07:53 AM

B&Q polycarbonate glazing pack
 
One problem I encountered with a B & Q greenhouse in the garden of the
house we moved in to a few years ago was that the polycarb' sheeting (said
to be ideal for greenhouses) I bought from a supplier was bowed in the wind
to such an extent that it came out of the frame. Obviously a design problem
because the greenhouse windows are approx. 29 inches wide which is much too
wide to allow thin polycarb' sheet's stiffness to prevent it being blown
out.

On the thin polycarb sheets I had used in other positions I braced them with
thin wooden slats to prevent bowing.

I have recently replaced two more glass windows (safety considerations) in
the greenhouse but used polycarb sheets twice as thick and braced them too!
I bought greenhouse spring clips from an ironmonger's and to prevent them
collapsing the polycarb' I stuck short metal strips on the pollycarb'
where the springs would be.

By the way, It's adviseable to seal the top edge of the polycarb uning a
decent waterproof strip. I used an aluminium adhesive backed strip -
expensive but worthwhile for the sunlight does not degrade it.

Geoff




All times are GMT +1. The time now is 09:48 PM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
GardenBanter