Welp, the little red soda straw fell out today. Can that thing be shoved
back in the hole, or does it require some type of adhesive (or replacement)?
Anyone know?? I have no idea what it is for. I thought fuel would come out
of it if I pushed in the primer bulb, but it doesn't. The primer bulb blows
up like a balloon though if you blow into the tube. Can anyone provide an
explanation here?

"Bill" wrote in message
news:uBZxa.890292$3D1.510169@sccrnsc01...
Greetings! I noticed from some of the posts that there are lawn mower
repair
savvy folks that monitor this group. I'm looking for some help with my
mower. I have mowed 3 times with it this season. Each time it has run like
new. The other day, I decided to spray it down with the garden hose to
clean
it up. I have mowed with it one time since the cleaning, and it ran great.
The other day, I tried to start it up, and after I prime it, it runs for
about 3 seconds and dies. I can continue to pump the prime bulb and it
will
stay running. I drained the gas tank, pulled the carb off and blew it out
with compressed air, inspected the float and needle valve--good, put it
all
back with new gaskets, put on a new air filter, installed a new spark
plug,
checked the main vacuum hose going from the block to the top of the carb
and
it looked new, filled the gas tank with fresh fuel, and after all that,
the
mower still only runs 3 seconds after I prime it. It is a pos Tecumseh
engine with no obvious carb adjustments. The mower is probably 3 years
old.
I can keep it running by taking the air filter off and partially closing
the
rear air inlet hole on the carb with my fingers, but that makes it tough
to
mow with. Anyone have any ideas?