I can tell you, it takes about an hour or so for me. I'm just beginning so
that's just my experience. I don't start the injection until I see a layer
of tiny bubbles on the surface.

bob


"Frank Mamone" wrote in message
.. .
Jody,

How long does it take for you to get bubbles after you prepare a fresh
batch?

Thanks,

Frank

"Jody" wrote in message
. ..
That's not a lot of bubbles for a fresh batch of a DIY yeast mixture.
Maybe
you have a leak? I usually get about a bubble per second with a new
batch.

Jody

"Bob A" wrote in message
...
First I want to thank everyone who has helped me get started on DIY
CO2,
and
especially Kush who told me I might be using water that was too hot...
that
was in fact the problem.

I also read Leigh's response to someone regarding doubling the amount
of
mixture in the bottle, and did that, and it gave me more frequent
bubbles
than I had had, but the pH didn't go down.

I'm getting a bubble about every 3-4 seconds, piped into the intake of
my
Emperor 400 power filter. My CO2 normally has been about 2-3, now it
is
staying a fairly stable 8ppm (KH 2 & pH 7).

I am even seeing a little pearling which is very rewarding. My
question
is,
should I be satisfied with this? I would love to see more pearling,
but
I
don't necessarily want extra-rapid plant grown... I would like them to
grow
of course, but.... I think you understand.

Also, I'm suspecting the Emporer is not making the best use of the CO2
I'm
getting. Are there any suggestions that aren't (1) very expensive (2
and
more important) won't look ugly in my tank.

thanks so much,

bob