Thanks for the reply folks. I think I am going to give the MSU a try. It is
a bit hard to find in Canada. I did find a source on Ebay, and it is mfg by
the "Blackmore Comany", if that means anything.

Ray:

That pic of the Inobulbon munificum. is beautiful and stunning to say the
least.

Cheers



"Ray" wrote in message
...
I have been using the GreenCare RO-water version since April of 2003. It
is designed to be used at 125 ppm N for continuous feeding (i.e., at every
watering). For about the first three- or four months, I used it at about
half that concentration, but ever since I decided to simply go with the
stated rate.

Since using it, I see faster growth, larger plants - including phals,
paphs and phrags with more leaves - and more reliable blooming. Most of
my vandaceous plants bloom at least twice a year, many three times, when
they were only annual bloomers previously.

Of most significance to me was the fact that several plants that had done
essentially nothing for extended periods of time sprang back to active
growth several months into this period. For example, I managed to "fry"
an Encyclia atrorubens when recovering the greenhouse. The pseudobulbs
were plump and green, but there were no leaves. For close to two years it
stayed that way - not desiccating, but no new growth. About two months
after starting with the fertilizing regime, a new growth sprang to life,
and it has grown and bloomed reliably ever since. I had a similar result
with Inobulbon munificum. It grew very slowly and never carried more than
one new pseudobulb to maturity before the last would start to wither, and
no blooming. After about a year or so under 'the treatment" it bloomed
(photo at a.b.p.o), and has been growing bigger each year.

Don't get me wrong. I do not think the MSU stuff is "magic." I switched
from using Dyna-Gro "Grow" formula at about 75 ppm N, so a lot of the
increased vigor could be merely due to increasing the feeding rate. The
use of the RO formula also saves me from making adjustments. Using D-G in
RO gives an exceedingly acidic pH, so it was necessary to make an
adjustment before feeding, and I did so with Pro-TeKt. With the size of
my collection, I feed via a dosing pump, and one cannot add "Grow" and
Pro-TeKt concentrates to the same tank, or all kinds of minerals will
precipitate. I, therefore, had to have two dosing pumps, monitor the
outputs of each, and verify the pH of the output.. With the GreenCare MSU
formula, I mix the powder in one tank and I'm ready to water.

I do believe that the formulation has an advantage with lower phosphorus.
The plants don't need all that much, so there is less being dumped into
the environment to potentially cause eutrification in ponds. The
Commonwealth of Pennsylvania (among other states, and all of Canada, I
believe) are starting to monitor and regulate phosphate waste in
agriculture, so it's nice to know that I'm contributing less to the
problem. (I am aware of a drive for phosphate reduction in oil drilling
muds in Canada, so I assume the ag part is there, are will be.)

--

Ray Barkalow - First Rays Orchids - www.firstrays.com
Plants, Supplies, Artwork, Books and Lots of Free Info!


"Bryan" wrote in message
news:rD32f.118984$1i.74537@pd7tw2no...
Hello:

Anybody using MSU fertilizer care to comment on it's effectiveness etc...

-=Bryan=-