"CanadianCowboyİ" wrote in message
...
Snooze wrote:
"Gareeeİ" wrote in message
...
Note: Use a DC wall adapter for power with 1 - 2 Amps output.
ie: 12 volts DC with a 20 watt bulb
Sounds like he's talking about the DC wall adaptors you get to charge
cell phones, portable electronics, cordless phones etc. Just cut the end
off, usually a barrel tip.
On the adaptor it will say something like input: 120v ac, output 9v dc
500 mA. In this case you're looking for something that has an output of
12v dc and 1000 mA, which will give you a slightly dimmer bulb, but a
longer bulb lifespan. An output if 12v dc with 2000 mA would give you a
brighter bulb.
If you can't find one in that kitchen drawer, or your local electronics
surplus shop, or radio shack, then there's always mail order.
http://www.allelectronics.com/matrix...nsformers.html
Good luck
Yeah ...I'm an electronic technologist so I have lots of these
transformers lying around. I never throw one out from old phones or games
etc.
Yes ...if you want the full Wattage from the bulb then
ex: 12 volt bulb at 20 watts 20W/12V= 1.67 Amps is the minimum transformer
you will need but as you said if you want lower brightness then you can go
lower as you please.
even if you look hard on e-bay this would cost you about $30.00.
I figure the homemade one will cost you under $10.00 and even less if you
have the transformer lying around.
I save all those old transformers as well.. I'll have to root around and see
what I have here.
Thanks for all the info!