No, if yuy go with a Cyprio Titan pump of say 800 gph its made to
power a pressure filter like the Cyprio Bio Force, and then feed a
water fall .....Commn box filters just plain suck at removing any
algae or really doing the job, and who want to be messing around in a
pond to clean it. External pressure buried so only the top is visible
is a piece of cake to maintain. At the price your just a bit higher
than what big box stores charge for a typical box filter and cleap
pump.


On Tue, 06 Jun 2006 20:38:03 GMT, "Steve" wrote:
So basically no matter what pumps I chose to use I should probably just get
one pump and filter set up and one waterfall pump. Correct?



"Go Fig" wrote in message
...
In article , Steve
wrote:

Well I have been reading for a few weeks and finally decided to do a
pond.
I will probably just put a few small goldfish in it nothing big. It will
be
a preformed one from HD 165 gallons and 18" deep. I will bring in the
goldfish in the winter to an aquarium ( i have 4 of them).

My questions is : I will be getting a pump and filter combo (Beckett
Small
Pond Filter Kit Model 7040210). Will I be able to run a waterfall that
is 2
ft high and about 3 feet away from where the pump will be located?

It is very doubtful that this matched pump will run this proposed
waterfall with more than a small trickle (perhaps the desirable
effect)... consider using a 2nd pump to run the waterfall... a
Pondmaster #12 might be a good choice w/ 1" tubing for a strong flow/
rate.

Have you looked at the Pondmaster filter w/ a skimmer ?

Good Luck!

jay
Mon Jun 05, 2006



I
noticed that it has a valve for other water features on it so that is
what I
was going to hook up to it. I will use the fountain attachement also.

Thanks in advance. It is all confusing to me. I am jsut not wanting to
spend money on two pumps if not needed.

Thanks
steve