Thread
:
[IBC] Removing Tool Rust?
View Single Post
#
1
22-03-2003, 08:56 PM
David J. Bockman
Posts: n/a
[IBC] Removing Tool Rust?
John,
I've had good luck dumping the tools into a drum of turface fines (but dry
sand would work great) and then rolling it to and fro for a few minutes. The
tools come out spotless.
David J. Bockman, Fairfax, VA (USDA Hardiness Zone 7)
Bunabayashi Bonsai On The World Wide Web:
http://www.bunabayashi.com
email:
-----Original Message-----
From: Internet Bonsai Club ]On Behalf
Of John T. Jarrett
Sent: Saturday, March 22, 2003 2:34 PM
To:
Subject: [IBC] Removing Tool Rust?
:/
I just found a tub of tools I thought I had put in the garage
before winter
came.
Any good soaks for getting the rust outta them creases and seams where
grinders and sandpaper don't reach?
I used a half vinegar - half water tub to clean up a cast iron
pot that had
spent ten years in a garage, but that still took hours of wire
brushing and
these tools are just too small for that.
************************************************** ******************************
++++Sponsored, in part, by Evergreen Gardenworks++++
************************************************** ******************************
-- The IBC HOME PAGE & FAQ:
http://www.internetbonsaiclub.org/
--
+++++ Questions? Help? e-mail
+++++
Reply With Quote