"Rog" wrote in message ...
"Dave Fawthrop" wrote in message
...
On Sun, 06 May 2007 09:07:01 +0100, judith wrote:

|!I had really struggled to find some long (three quarter inch) cropped
|!bolts.

When I was an apprentice mumble years ago I *made* a tool to do this,
unfortunately metrication has made them useless. Must make a metric
one.

Drill and tap a hole in a 1/4 inch thick bit if mild steel about 1 inch
wide. Saw through centre of the hole, lengthwise in mild steel. Put
long
bolt in tapped hole. Put tool in vice squeezing shut saw cut. Hacksaw
bolt to length as required.
--
Dave Fawthrop sf hyphenologist.co.uk 165 *Free* SF ebooks.
165 Sci Fi books on CDROM, from Project Gutenberg
http://www.gutenberg.org/wiki/Main_Page Completely Free to any
address in the UK. Contact me on the *above* email address.


Was that Whitworth or BSF? ;0)

--
Rog
http://www.rog.richieward.com


1/4 BSF when I did a similar operation in 1952 :-((

Loved to work in BA sizes :-))

Then went onto Metric before I went into Marine Electrical Design :-))
Management :-)) and off my tools :-))

Mike


--
.................................................. ..............
The Royal Naval Electrical Branch Association.
'THE' Association if you served in the Electrical Branch of the Royal Navy
www.rneba.org.uk