On Fri, 6 Jul 2007 12:57:59 CST, "Goldlexus"
wrote:

It is kinda protected. It has a lot of rocks around it, the suction hole is
on the bottom of the pump not the kind that sticks out the side, it has a
gutter gauard around it to keep fish from getting sucked up. So far we have
moved a lot of rocks around it, we were unable to get fully under the pump
but thought maybe it was cleared enough. We plugged in the pump and it has
more water volume than before but not where it should be. The pressurized
filter usually reads just under 5 psi, when we plugged it back in just now
it read just a little over 3 psi. Prior to clearing somethings around it it
read barely 2 psi. So we are on the right track I think just didn't get it
all maybe. I don't know In the meantime the pipe that comes to the top
of the filter has a sprung a pin whole leak so we need to fix that. So we
have the pump off until we can get in there a clear more rocks and repair
the pin whole leak. BTW while we had the filter apart we sprayed water thru'
the pipe back into the pump to hopefully push out what ever may be there.
Our pump is a sump pump and is suppose to handle solids up to 2".

If you have to pull the pump out, and I'd suggest you do. Clear the area
around the impeller. Then put the pump in something like this:

http://users.owt.com/jjspond/koipond/photos/set1/09.jpg

Even though the pump can handle solids, a 2" rock, snail shell or fish
parts could clog it or slow it down. The mesh baskets give lots of surface
area. I've had the lily pond one done like this for 2-3 years now, and
haven't had a need to pull it out of the pond. ~ jan
------------
Zone 7a, SE Washington State
Ponds: www.jjspond.us