New Hunter Sprinkler Heads
On Jul 1, 12:28*am, Ron wrote:
On Jun 30, 11:32*pm, dnoyeB wrote:
On Mon, 30 Jun 2008 20:14:31 -0700, RicodJour wrote:
On Jun 30, 10:38 pm, "hr(bob) "
wrote:
On Jun 30, 8:50 pm, wrote:
On Jun 30, 10:19 am, dnoyeB wrote:
I am going to change my heads to cut the flow in half on each of my
zones. *What type of tools and supplies do I need to accoplish
this?
I have Hunter PGP and PGM heads mostly.
Also, is there a good supplier for these items?
Thanks,
CL
You could do it with just an allen wrench and the new nozzle, but it
won't be easy. * * To do it the easy way, Hunter makes a key like
tool. *One end of the key gets inserted into an opening on the head
and then you can pull the rotating head up out of the head cylinder,
just like it would come up with water pressure. * *They have a second
clip-on device, which then snaps on to lock it and hold it up while
you work on it. * The other end of the tool has the allen wrench of
correct size to take out the set screw that adjusts the water throw
distance and also holds the orifice in. * After taking out the screw,
you can pull the old nozzle out with a pair of needle nose pliers and
press the new one in.
You can find the two tools either online at shops that sell Hunter or
at a local plumbing supply.
If you are putting on too much water, save the money, buy a new timer
that lets you reduce the amount of time the sprinklers are on.
Why would the OP need to buy a new timer? *Couldn't he just set it for a
shorter period of time on each zone if that was the problem? *The OP
might have a flow rate problem and the existing heads aren't providing
full coverage.
dnoyeB, please flesh out your question a bit. *Why do you want to change
the heads? *Are there failed seals and water is leaking out along the
body? *Pressure/flow issues?
I am using reclaied water source. *I cant push 18GPM. *I can handle around
9 though. *So I am looking to reduce the GPM by changing heads if I can.
|