On 05/05/2011 06:02, harry wrote:
On May 4, 11:36 pm,
wrote:
Hi,
I'm a newbie here. I've just bought a secondhand 8x10 Alton greenhouse
and now must go and dismantle and collect it from the seller.
I'd like advice about the best way to do this... eg should I remove all
glass or transport the panels with glass in situ?
I've ordered a complete set of assembly hardware from Alton so I can be
savage when dismantling and use new screws etc when reassembling.
What sequence should I dismantle - eg roof....walls... ends. Or roof...
ends...walls?

I've downloaded the assembly instructions from the Alton website and
notice that there is mastic used along the ridge. Is this easy to
access and cut through with a Stanley knife?

I will be hiring a van to transport the greenhouse and will need to
bring all the tools I'm likely to need (screwdrivers, saw, knife,
spanners) Anything else?

--
Tractorboy

You will need to take all the glass out. If your van is big enough
you may then be able to transport the larger sub-assemblies which
would save a lot of work. (Or on roof rack?) If not, you will have to
completely dismantle it.


The main problem is transporting the glass without breaking it. It
needs to be clean and stacked on it's edge. You will need something to
prop the glass up and cushions or carpets to stand it/on wedge it to
stop it falling about.
Cardboard boxes, rope, bungey ropes, small tyres?

Don't forget that old glass is a lot more brittle than new glass, and
can crack and chip very easily.

--

Jeff