Consider this, it takes 27,154 gallons to apply 1" of water to 1 acre. You
need to figure the flow rate of the spring and then the area you plan to
irrigate. Generally you would need this water during the drought. Are you
sure the spring is viable in the summer?

--
Baine

"Robert Gray" wrote in message
. com...
Well,

I have finally got around to backfilling drainage pipes in the culverts of
my yard. In one part of the yard, there was always a soft spot. Turns out
that it is a natural spring, and it continues to bubble up through the new
fill.

It is close enough to a drain (20') that I think I can excavate the fill
and
put in a french drain to trap the water and direct it to the the drain
before it reaches the surface. Some landscape fabric, a truckload of
gravel,
some slotted drain pipe, and a day or so of digging, installing and
backfilling and it should work.

But, before I do that I thought I would check with others about the
possibility of using the water for irrigation. We have had some long hot
summers without much rain lately, and the spring is ideally located to
service an area (where I will plant grass and shrubs) that is far from the
water of the house. We do not have any other type of sprinkler systems (on
a
well), but this just might make sense.

I have ideas of burying a holding tank, directing the water into the tank,
and then pumping it out into a pressurized tank for the sprinkler lines.
But, I haven't done anything like this before and need some technical
references to see if it is viable.

Anyone have experience they would like to share?

Thanks,
Robert