Simoniz pressure washer serious problem
 

I bought a Simoniz Pressure 1400 psi washer 2 years ago, it has been
working fine until recently. The problem is, after I turn it on the motor
cannot stop although the water comes out with the right pressure. The motor
is supposed to stop when releasing the trigger, but it doesn't. EVEN WORSE,
when I switch the unit to OFF position, the motor is still running!!! It
seems like a bad design because the power switch doesn't even kill the
incoming 110V !! So, I had to pull the plug in order to stop it.

My friend is having the same model , and has exactly the same problem.
Anyone knows how to fix it?

Simoniz pressure washer serious problem
 

Sounds like the pressure switch is stuck on. Could be caused by a piece
of dirt inside the switch or rust or crud holding it closed. Could also
be the contacts were cheap and have welded themselves shut. Shouldn't be
hard to pull it apart and repair the switch.

--
Steve

"Andy Kalsey" wrote in message
able.rogers.com...
I bought a Simoniz Pressure 1400 psi washer 2 years ago, it has been
working fine until recently. The problem is, after I turn it on the
motor
cannot stop although the water comes out with the right pressure. The
motor
is supposed to stop when releasing the trigger, but it doesn't. EVEN
WORSE,
when I switch the unit to OFF position, the motor is still running!!!
It
seems like a bad design because the power switch doesn't even kill the
incoming 110V !! So, I had to pull the plug in order to stop it.

My friend is having the same model , and has exactly the same problem.
Anyone knows how to fix it?






-----= Posted via Newsfeeds.Com, Uncensored Usenet News =-----
http://www.newsfeeds.com - The #1 Newsgroup Service in the World!
-----== Over 100,000 Newsgroups - 19 Different Servers! =-----