Mountfield Mirage height adjustment
Hi ev'ryone
The height of cut adjustment on these mowers is by a spring-loaded lever which is "sprung" into a quadrant on the right hand side by the back wheel. The spring has broken, so the lever slips out of the quadrant & the mower sinks down until the deck is on the ground. I've got a new spring but I can't fit it because I cant tension the new spring before slipping it onto its shaft! Has anyone out there had to change this bit & have they any advice! Note I've removed the right hand side rear wheel, removed the pin that carries the lever & spring from its housing but am stuck on re-assembling with the spring tensioned Any advice gratefully accepted TIA regards: Frank |
All times are GMT +1. The time now is 08:02 AM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
GardenBanter