Home |
Search |
Today's Posts |
#1
|
|||
|
|||
Mountfield Mirage height adjustment
Hi ev'ryone
The height of cut adjustment on these mowers is by a spring-loaded lever which is "sprung" into a quadrant on the right hand side by the back wheel. The spring has broken, so the lever slips out of the quadrant & the mower sinks down until the deck is on the ground. I've got a new spring but I can't fit it because I cant tension the new spring before slipping it onto its shaft! Has anyone out there had to change this bit & have they any advice! Note I've removed the right hand side rear wheel, removed the pin that carries the lever & spring from its housing but am stuck on re-assembling with the spring tensioned Any advice gratefully accepted TIA regards: Frank |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Broken Toro height adjustment spring/lever | Lawns | |||
Tropf Blumat adjustment | United Kingdom | |||
Help - Carburetor adjustment instructions Punch 30s | United Kingdom | |||
co2 regulator adjustment | Freshwater Aquaria Plants | |||
co2 regulator adjustment | Freshwater Aquaria Plants |