Thanks: I will turn it down. Makes sense to me.

Dan

"Bill Stock" wrote in message
...

"Dan" wrote in message
...
I have recently installed a CO2 system in my 75 gallon aquarium and it is
working fine except for one little problem. I have a constant pH reading
of 7.1 thanks to the addition of CO2. Before CO2 my pH was 8.4. Very
hard water.

The problem is that when I fill my bubble counter half full of water, I
lose it all within a week. I believe the bubble flow rate is too fast
and the large flow is causing the water to dissipate into the CO2 air
tubing. I replace it and then is starts over again.

I know the answer is to turn down the flow rate, but then the CO2 runs
all the time on my pH controller. Isn't it supposed to shut off and then
when the pH spikes a little, it automatically turns it back on? I am
afraid if I turn down the flow rate, my pH will go higher than I want.
The pH is stabilized at 7.1 now so does it matter if there is water in
the bubble counter at this point anyhow?

Advice is appreciated from those with more experience and thanks.

Dan


Ideally your bubbles should be low enough that your controller is almost
always on. That way you don't get any PH fluctuations and if your solenoid
gets stuck open you won't poison your tank. Although I can't say that mine
is set that accurately.

My bubble counter is connected to the venturi input of a powerhead (RUGF),
so it never stays full of water. The venturi sucks the water right out.But
since I don't rely on the bubble counter (PH Controller) it's doesn't
matter all that much.