Home |
Search |
Today's Posts |
#32
|
|||
|
|||
Amun wrote: "Jeff Wisnia" wrote in message ... benzette wrote: Is it harder then before to pull start or is it just taking more pulls to start it? Maybe try premium gas. Let it run out of gas before putting in new premium or drain the other gas out. Premium gas won't ignite any easier than regular gas in a lawn mower engine. Premium gas has a higher octane rating which means it suffers less preigniting from the heat of compression in high compression auto and aircraft engines. It'll just waste Betsy's money, Benzette Jeff Jeff is right, the difference between regular and premium is minimal. And to be honest, as most gas stations sell such a small amount of premium gas compared to regular. The regular is usually fresher and still fully potent. Many times the premium is already weeks old, and slightly dead. Not that it matters for her problem, but gas does not go bad in few weeks under normal conditions. A month or two would be more of a likelihood of such a problem. If she had her gas in the tank for that time period, it could have gone bad. That is why I suggested she put in a product like Stabil just after buying the gas. If her gas is that old, it's too late to protect it, so she should dispose of it and get fresh stuff. People who have high compression engines that need the premium will know what I mean. But at the low compressions in a lawnmower it doesn't make any difference anyway. Save the 20 cents and buy the regular. But you can add a very small amount of gas line deicer (PURE methyl/ethelene hydrate/ alcohol) if you have a bit in the garage. (NOT the rubbing alcohol from you medicine cabinet that already contains water) Most gasolines already have about 10% alcohol in them, at least in my part of the USA. If she bought her gas without the alcohol in it, she is better off going to a different gas station who might not have water in the bottom of their tanks, or finding a station that sells gasahol. My vote goes for stale gas, not gas with water in it. But mix it into the gas can as you only need a few drops per lawnmower tank full. (quart) It helps the gas fire a slight bit hotter and help pass any water/condensation/scale through the carburetor It may not help with your starting, but it can't hurt it. I would recommend a product called SeaFoam, available from most auto stores to treat the gasoline to both clean the carburetor and stabilize the gas (similar to the Stabil product I mentioned earlier). If she did not run the gas out of her engine last season, these additives probably won't work, and she will need to have the carburetor cleaned by a mechanic. Then pour the rest of the bottle into your car gas tank. It may not pay to fix it, but I would bring the lawnmower somewhere else to see if anyone else can locate the problem your neighbor seems to be missing. It could be, dirt in carb, bad/ misadjusted/weak ignition module, pinched spark plug wire, bent flyweel key, bad plug. But it's impossible to tell from a usenet post. These things are almost all cheap for parts to fix, but labour could cost $100 or more. It would help to know if the motor is a briggs & stratton, tecumeth, or some other make, but I'm going to assume Briggs. Offhand I'd check the spark plug wire is not pinched/cut in the starter-flywheel shroud where it goes out to the spark plug since that was removed shortly before the problems began. (to change the pullcord) Even an experienced person can do this easily if they aren't careful as there is only a slight bend in one spot for the wire to pass through without being damaged If you can get the mower into the dark, try to start it and watch to see if little faint blue sparks may be going right through the wire to the engine case Depending on the mower this wire can be part of the coil assembly, or replaceable separately. And sometimes just a bit of black electrical tape/shrinkwrap over the wire can get you going again. A broken ignition wire is highly unlikely, but not impossible. I would do a more positive test of taking the plug out of the mower, but leaving it connected to it's lead wire. Then set the body of the plug next to a large metal surface of the mower. Pulling the starter cord should then produce a healthy spark at the plug. If it doesn't, she has an ignition problem such as a bad plug, ignition coil, etc. But as already said, this is just an internet guess. AMUN |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
747 Lawnmower ?..............Yes, this is real, a flying Lawnmower | Gardening | |||
747 Lawnmower ?..............Yes, this is real, a flying Lawnmower | United Kingdom | |||
747 Lawnmower ?..............Yes, this is real, a flying Lawnmower | Lawns | |||
help - can't crank lawnmower - need to mow | North Carolina | |||
help - can't crank lawnmower - need to mow | North Carolina |