Home |
Search |
Today's Posts |
#16
|
|||
|
|||
Karcherpower washer spray problem
"John" wrote in message ... Oh no ---not a cheap Karcher at almost £200 from their main suppliers! and the wand (Lance) and the replacements were all genuine Karcher parts. ---You want to try again with some help? Or anyone else who can give a realistic answer to my problem---------- I think you will find the problem is caused by either hard water deposits or grit getting back up into the nozzle Its vital when storing Karchers for the winter to store with the nozzle up so that water etc runs back down into the hose I also know of a small engineering Co who will replace just the nozzle for a few £ instead of the £60 it costs for a replacement wand " |
#17
|
|||
|
|||
Karcherpower washer spray problem
can you please adjust the date on your PC. Unless you are posting from the
future in which case the date may be correct for you. |
#18
|
|||
|
|||
Karcherpower washer spray problem
On 16/6/06 17:37, in article , "fenwoman"
wrote: can you please adjust the date on your PC. Unless you are posting from the future in which case the date may be correct for you. Who? -- Sacha www.hillhousenursery.co.uk South Devon (email address on website) |
#19
|
|||
|
|||
Karcherpower washer spray problem
John wrote:
Hi, I realise I am only just on the "Fringe" posting with this, but perhaps someone can help or direct me to a more appropriate Board. John Not only that, John, you're a voice from the future. It may never happen by the time we get there. |
#20
|
|||
|
|||
Karcherpower washer spray problem
Hi, I realise I am only just on the "Fringe" posting with this, but perhaps
someone can help or direct me to a more appropriate Board. In my garden I have a lot of paving slabs that I clean with a Karcher power spray . The machine works fine, but I have problems with the "Wand". I have bought two extra ones over a period and they all set off ok but when I come to use after a winter they do not emit the same power of spray as they did previously. The problem is that the brass spray nozzle does not appear to fit dead centre with the outer plastic slit thus causing it to loose a lot of power. Well that is what it seems to me. The result is that to get any power I am having to hold the end of the wand to only 2" to 3" off the ground, thus reducing the width of spray and taking forever. Has anyone else experienced this and found an answer to the problem Thanks for any help John |
Reply |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Problem Cranking Power Washer..Tough Cord | Lawns | |||
Simoniz pressure washer serious problem | Lawns | |||
Which Pressure washer? | United Kingdom | |||
30 year old washer question | Lawns | |||
Pressure washer help | Lawns |