LinkBack Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #16   Report Post  
Old 11-09-2004, 02:59 AM
JB
 
Posts: n/a
Default

Roy (and anyone else),

The tiller for your JD317 was belt driven was it not? I'd heard that there
were problems with belt driven tillers. The local JD salesman where I live
said he rarely sells them. I'm looking at an JD LX 280. Would this model
with tiller do a good job breaking ground and keeping a garden tilled, in
your opinion?

Thanks.


"Roy" wrote in message
...
I would have to dissagree on needing gears if you pull heavy loads. I
would be hard pressed to believe the gears in most typical L & G
tractors are all that much stonger than a good hydrostatic drive unit.
MOst consumer type L & G tractors are offered as baaaseline units with
minimal everything be it gears or hydrostatic drives. I had a JD317
with over 4000 hours on it when I finally got rid of it, and it was a
hydrastatic drive, and it was used hard and put up wet all the time,
and it was used to pull more than what it should have all the time. I
used to drag around a trailer full of firewood that weighted about 5
or 6000 pounds. It was used for ground tillage and breaking in the
garden I had back then, 1 1/2 acres and it never missed a beat.

I now have a JD GX335 with hydro and its just as good as the 317
was..You do not need gears to pull things with and they certainly do
not make it any more efficient or stronger. The JD lineup of the L
series is built for light pulling loads as are most other similar
units.

Nnnothing could be easier and more trouble free than the layout JD
uses with their twin touch pedals. Throttle it up and go.......push
harder on the pedal you have ore speed and torque. No need to come to
a complete stop before hitting the reverse pedal either, so cycle time
and fuction is a lot quicker with a hydrastatic drive with twin pedals
than anay setup using strictly gears can even think about being. More
andmore heavy dury industrial equipment is being suypplied with
hydrostatic drives each year. Its a proven fact they are just as
strong when it comes to use and pulling with and will last just as
long.
Visit my website: http://www.frugalmachinist.com
Opinions expressed are those of my wife,
I had no input whatsoever.
Remove "nospam" from email addy.



 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is Off
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Lawn Tractors/Mowers Wyatt Wright Gardening 56 15-09-2004 07:56 AM
Need advice on lawn tractors (Deere vs Snapper) [email protected] Lawns 1 20-07-2004 05:05 AM
Ridng Lawn / Garden Tractors evolutionman 2004 Lawns 10 10-05-2004 03:08 PM
blades for lawn tractors, difference in quality? Joe Zorzin Lawns 6 22-07-2003 10:47 AM
Lawn Tractors Declan United Kingdom 0 18-05-2003 09:08 PM


All times are GMT +1. The time now is 08:18 AM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 GardenBanter.co.uk.
The comments are property of their posters.
 

About Us

"It's about Gardening"

 

Copyright © 2017