Home |
Search |
Today's Posts |
#1
|
|||
|
|||
Large tank Leveling
I'm in the process of setting up my new 150 Gallon Planted tank. 72X18X24
I've noticed a 1/8 of an inch slope along the width of the tank and a 1/8 of an inch slop along the width. First is this something to be worried about? If so, what's the best way to level the tank? The tank is sitting in an All-Glass stand which supports the tank all along the edges, but the bottom area is open. Any suggestions/comments would be great. TIA Ian |
#2
|
|||
|
|||
Large tank Leveling
Yes, definitely worry about it. If the stand isn't level there will be
uneven stress on the glass walls of the tank and on the structure of the stand itself. You can use carpenters wedges. They're cheap little pieces of scrap plywood which are used for leveling when installing cabinetry and such. You wedge pieces in until the unit is level and then snap off, cut, or otherwise break off the excess. On finished cabinetry this is done from the inside of the unit so the wedges don't show but, as I recollect, The AllGlass stands have a fiberboard floor or some-such. You might want to pop the floor off if the wedge stubs are going to show? I've been known to wedge coins under the corners, albeit not on a setup that weighs nearly 2000 lbs. kush "You can't have everything - where would you put it?" Ian Mather wrote in message . ca... I'm in the process of setting up my new 150 Gallon Planted tank. 72X18X24 I've noticed a 1/8 of an inch slope along the width of the tank and a 1/8 of an inch slop along the width. First is this something to be worried about? If so, what's the best way to level the tank? The tank is sitting in an All-Glass stand which supports the tank all along the edges, but the bottom area is open. Any suggestions/comments would be great. TIA Ian |
#3
|
|||
|
|||
Large tank Leveling
I've noticed a 1/8 of an inch slope along the width of the tank and a 1/8 of
an inch slop along the width. First is this something to be worried about? If so, what's the best way to level the tank? The tank is sitting in an All-Glass stand which supports the tank all along the edges, but the bottom area is open. Any suggestions/comments would be great. TIA Ian What I use to level my tanks is lexan acrylic. I purchased 4"x6"x1/16" strips at Home Depot for a couple dollars. I then scored the pieces to size, then snap them . The pieces are clear,and very strong. N8 |
#4
|
|||
|
|||
Large tank Leveling
On Sun, 10 Nov 2002 21:15:11 GMT, "kush" wrote:
Yes, definitely worry about it. If the stand isn't level there will be uneven stress on the glass walls of the tank and on the structure of the stand itself. 1/8 of an inch across 72" definitely isn't going to hurt anything, and I doubt 1/8 of an inch across 18" is even going to be a problem. I've got about 1/2" slope across my 48" tank. Chuck Gadd http://www.csd.net/~cgadd/aqua |
#5
|
|||
|
|||
Large tank Leveling
Thanks Chuck, I didn't think it would be too bad, but to play it safe, based
on someone elses reponse I found some acrylic pieces in my basement which I used to level it. Now on to figuring out what I'm going to do to light up this big boy...with as little cash as possible. Ian "Chuck Gadd" wrote in message ... On Sun, 10 Nov 2002 21:15:11 GMT, "kush" wrote: Yes, definitely worry about it. If the stand isn't level there will be uneven stress on the glass walls of the tank and on the structure of the stand itself. 1/8 of an inch across 72" definitely isn't going to hurt anything, and I doubt 1/8 of an inch across 18" is even going to be a problem. I've got about 1/2" slope across my 48" tank. Chuck Gadd http://www.csd.net/~cgadd/aqua |
#6
|
|||
|
|||
Large tank Leveling
On Sun, 10 Nov 2002 20:47:29 GMT, "Ian Mather"
wrote: All my tanks are leveled up with match books, a box of match books is about a $1. they seem to work good, but mine are all on carpet floors and you can't really see the base of the stand/table, you may wish to find something a little more visually pleasing. However Chuck is probably right and it isn't anything to worry about. But If you can level it without too much trouble I would do it anyways. Foes I'm in the process of setting up my new 150 Gallon Planted tank. 72X18X24 I've noticed a 1/8 of an inch slope along the width of the tank and a 1/8 of an inch slop along the width. First is this something to be worried about? If so, what's the best way to level the tank? The tank is sitting in an All-Glass stand which supports the tank all along the edges, but the bottom area is open. Any suggestions/comments would be great. TIA Ian |
#7
|
|||
|
|||
Large tank Leveling
On Mon, 11 Nov 2002 02:26:26 GMT, "Ian Mather"
wrote: Now on to figuring out what I'm going to do to light up this big boy...with as little cash as possible. Looks like it will be tricky. I'd probably investigate some T8 tubes over-driven with an electronic ballast. Dig thru the newsgroup messages for some of Wayne Jones' messages on the topic. Very intesting, and it seems very cost effective. Chuck Gadd http://www.csd.net/~cgadd/aqua |
#8
|
|||
|
|||
Large tank Leveling
However Chuck is probably right and it isn't anything to worry
about. But If you can level it without too much trouble I would do it anyways. I don't know how people can look at a tank with an uneven waterline... it completely destroys the aesthetic effect for me ;-) But I suppose the rim partly hides it if you fill it high enough. Rebecca -- Get the lead out to reply by email. |
#9
|
|||
|
|||
Large tank Leveling
Normally I would agree with you, but in this case the tank has a full wood
cap which hides the water line. Ian "R.C. Keely" wrote in message .. . However Chuck is probably right and it isn't anything to worry about. But If you can level it without too much trouble I would do it anyways. I don't know how people can look at a tank with an uneven waterline... it completely destroys the aesthetic effect for me ;-) But I suppose the rim partly hides it if you fill it high enough. Rebecca -- Get the lead out to reply by email. |
#10
|
|||
|
|||
Large tank Leveling
On Mon, 11 Nov 2002 20:10:56 GMT, "R.C. Keely"
wrote: I don't know how people can look at a tank with an uneven waterline... it completely destroys the aesthetic effect for me ;-) But I suppose the rim partly hides it if you fill it high enough. Unless it's MASSIVELY uneven, it will be completely hidden behind the tank rim. If it were too uneven for the rim to hide it, then I'd strongly suggest fixing it. Chuck Gadd http://www.csd.net/~cgadd/aqua |
#11
|
|||
|
|||
Large tank Leveling
On Mon, 11 Nov 2002 20:10:56 GMT, "R.C. Keely"
wrote: I don't know how people can look at a tank with an uneven waterline... it completely destroys the aesthetic effect for me ;-) But I suppose the rim partly hides it if you fill it high enough. I can't stand seeing a waterline in a tank, even or not. Fill it up so that the water level is at least up to the rim. Chuck Gadd http://www.csd.net/~cgadd/aqua |
#12
|
|||
|
|||
Large tank Leveling
If it were in MY house, I'd want 1500 lbs. of water in a glass tank pretty
darn level. kush Chuck Gadd wrote in message ... On Mon, 11 Nov 2002 20:10:56 GMT, "R.C. Keely" wrote: I don't know how people can look at a tank with an uneven waterline... it completely destroys the aesthetic effect for me ;-) But I suppose the rim partly hides it if you fill it high enough. Unless it's MASSIVELY uneven, it will be completely hidden behind the tank rim. If it were too uneven for the rim to hide it, then I'd strongly suggest fixing it. Chuck Gadd http://www.csd.net/~cgadd/aqua |
#13
|
|||
|
|||
Large tank Leveling
Well I got it level and filled without any problems. With the pine cap on
top, the water line is completely hidden. If you want an idea of what the tank looks like...see the attached URL..Only mine is black. http://www.all-glass.com/products/st..._cherry_4d.gif "Chuck Gadd" wrote in message ... On Mon, 11 Nov 2002 20:10:56 GMT, "R.C. Keely" wrote: I don't know how people can look at a tank with an uneven waterline... it completely destroys the aesthetic effect for me ;-) But I suppose the rim partly hides it if you fill it high enough. I can't stand seeing a waterline in a tank, even or not. Fill it up so that the water level is at least up to the rim. Chuck Gadd http://www.csd.net/~cgadd/aqua |
#14
|
|||
|
|||
Large tank Leveling
On Tue, 12 Nov 2002 00:49:58 GMT, "kush" wrote:
If it were in MY house, I'd want 1500 lbs. of water in a glass tank pretty darn level. But 1/8th of an inch over 6 feet is pretty darn level, less than 1 hundredth of a degree off level. And 1/8th of an inch over 18" is just three tenths of a degree off level. Both seem pretty darn level. Chuck Gadd http://www.csd.net/~cgadd/aqua |
#15
|
|||
|
|||
Large tank Leveling
Yes, but 150 gallons of water flowing across your living room floor is
pretty darn wet. Enough. I'm done. Horse has been flogged. Chuck Gadd wrote in message ... On Tue, 12 Nov 2002 00:49:58 GMT, "kush" wrote: But 1/8th of an inch over 6 feet is pretty darn level... |
Reply |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
question about leveling a lawn | United Kingdom | |||
Sloping soil - process of leveling and need help | Gardening | |||
Leveling a bumpy yard/lawn in DFW, Texas | Lawns | |||
Leveling lawn? | Lawns | |||
OT (Sort of) - Leveling the ground | Ponds |